消防电梯How to use

1. After arriving at the front room of the fire elevator on the first floor (or sharing the front room), the firefighters shall first break the glass sheet protecting the fire elevator button with the hand axe or other hard objects they carry with them, and then place the fire elevator button in the connected position。Depending on the manufacturer，The buttons also look different，Some only have a small "red dot" painted on one end of the button，When operating, press down the end with the "red dot";Some have two action buttons，One is black，It's marked "off" in English，The other one is red，It's marked "on" in English.，When operating, press the red button marked "on" to enter the fire state。

2, after the elevator enters the fire state, if the elevator is in operation, it will automatically drop to the first floor station, and automatically open the door, if the elevator has stopped at the first floor, it will automatically open。

3. After the firefighters enter the fire elevator car, they should press the door close button tightly until the elevator door is closed. After the elevator starts, they can let go, otherwise, if they let go during the closing process, the door will automatically open and the elevator will not start。In some cases, just pressing the close button is not enough, you should press the button of the floor you want to reach with the other hand while pressing the close button, until the elevator starts to let go。

keyword:Hunan Elevator

Article source: http://www.alexblog.net/